32DPF702.A
2 - 17
3. CRIMPED - 1.5mm
2
WIRE
a. Refer
to
Figure 2-27
. Strip approximately 4.75
±
0.38mm of insulation by using the appropriate wire
stripping tool for a 1.5mm
2
wire.
FIGURE 2-27
b. To easily insert the bare conductor into the terminal, straighten the tip of the bare conductor.
c. Refer
to
Figure 2-28
. Insert the stripped wire and the pin 350551-1 into the crimping tool 91500-1 and
crimp them accordingly.
NOTE:
Make sure that the tip of the bare conductor is exposed about 0
∼
1.0mm from the pin.
NOTE:
Make sure that the pin’s insulation barrel firmly holds the insulation.
NOTE:
Make sure that the bare conductor does not stick out from the pin’s wire barrel.
FIGURE 2-28
d. Insert the cap 1-480701-0 or 1-480705-0 into the prescribed location.
e. Refer
to
Figure 2-28
and
2-29
. Push the cable into the cap until the lances of the pin get caught by the
cap.
f. Verify that the cable does not readily pull out from the cap.
NOTE:
If the pin was inserted incorrectly, pull the pin out of the cap by using the specified tool (1804030-1 amp). Pay
attention not to squash the lances.
NOTE:
If the lances were squashed or bent, crimp the pin once again.
FIGURE 2-29
