32DPF702.A
2 - 11
2. CONTROLLER
WIRING
WARNING!
MAKE SURE THAT THE POWER SOURCE IS DISCONNECTED WHEN
ROUTING WIRES. THERE IS DANGER OF ELECTRIC SHOCK IF THE
POWER SOURCE IS NOT DISCONNECTED.
a. Route the train body wires to the wire numbers shown on the terminal board of the controller.
b. Refer to Crimped Ring sections for installation of crimped ring terminals, pages 2-12 and 2-13.
c. Refer
to
Figure 2-16
. Remove the screw that is located on the terminal board. Make sure that the Phil-
lips screwdriver is inserted perpendicular to the screw head.
d. Refer
to
Figure 2-17
. Insert the crimped ring terminal into the screw. Make sure that the crimped ring
terminal is not angled.
e. Refer
to
Figure 2-18
. Reinstall the screw into the terminal board. Make sure that the Phillips driver is in-
serted perpendicular to the screw head.
FIGURE 2-16
FIGURE 2-17
FIGURE 2-18
