2 - 12
32DPF702.A
3. CRIMPED RING- 1.5mm
2
WIRE
a. Refer
to
Figure 2-19
. Strip approximately 6.5 ~ 7.0mm of insulation by using the appropriate wire strip-
ping tool for a 1.5mm
2
wire.
b. To easily insert the bare conductor into the terminal, straighten the tip of the wire.
c. Refer
to
Figure 2-20
. Insert the bare conductor
into the crimping terminal PS2-4.
NOTE:
Make sure that the wire does not stick out from the insulation barrel.
d. Crimp the wire using crimping tool H-7.
e. After crimping, verify that the wire does not readily pull out.
f. Refer
to
Figure 2-21
. Make sure that the bare conductor is exposed about 0.5
∼
1.0mm at the base of
the terminal adjacent to the insulation barrel.
FIGURE 2-21
g. Visually inspect terminal to ensure that the crimping was done correctly. Verify that the bare conductor
does not stick out from the insulation barrel.
FIGURE 2-19
FIGURE 2-20
