2 - 14
32DPF702.A
D. CONTROL
PANEL
INSTALLATION
1. GENERAL SAFETY PRECAUTIONS
WARNING!
DO NOT TOUCH THE REAR SIDE OF THE CONTROL PANEL WHILE IT IS
POWERED. THERE IS A RISK OF ELECTRIC SHOCK AND/OR BURN INJURY.
WARNING!
DO NOT INSTALL THE CONTROL PANEL IN A LOCATION THAT IS ACCESIBLE
TO THE GENERAL PUBLIC AND PASSENGERS. THE CONTROL PANEL SHOULD
BE ONLY ACCESSIBLE TO THE OPERATOR WHICH WILL PREVENT
UNINTENDED OPERATION WHICH CAN RESULT IN INJURY.
♦
Handle the control panel with care. Do not throw or drop the control panel, as doing so could damage com-
ponents inside.
♦
Avoid contact with water. If water or excessive moisture is present, do not install or route the wires.
♦
Avoid areas with excessive dust.
♦
Never modify or dismantle the control panel.
♦
Avoid getting any foreign objects in the control panel during installation and wire routing.
♦
Install the control panel in a location that is out of reach from the general public and passengers and is
waterproof and dustproof. It is recommended that control panel be installed in a compartment with a key
which is only available to the operator.
♦
Install and tighten the M3 bolts on all four locations with a torque value of 0.63 Nm.
♦
Avoid interference with train parts and/or avoid touching the protuberance.
♦
Make sure wires or harnesses are protected and secured with cable ties every 18 inches (45cm).
♦
Use caution to avoid tearing or other damage to the insulation on the wires.
