32DPF702.A
2 - 13
4. CRIMPED RING- 6mm
2
WIRE
a. Refer
to
Figure 2-22
. Strip approximately 9.0 ~ 9.5mm of the insulation by using the appropriate wire
stripping tool for a 6mm
2
wire.
b. To easily insert the bare conductor into the terminal, straighten the tip of the wire.
c. Refer
to
Figure 2-23
. Insert the wire into the crimping terminal PS5.5-5.
NOTE:
Make sure that the wire does not stick out from the insulation barrel.
d. Crimp the wire using crimping tool H-8.
e. After crimping, verify that the wire does not readily pull out.
f. Refer
to
Figure 2-24
. Make sure that the bare conductor is exposed about 0.5
∼
1.0mm at the base of
the terminal adjacent to the insulation barrel.
FIGURE 2-24
g. Visually inspect to ensure that the crimping was done correctly. Verify that the bare conductor does not
stick out from the insulation barrel.
FIGURE 2-23
FIGURE 2-22
