Part IV Setting Parameters
46 BECS-09 Singular-head Computerized Embroidery Machine
will embroider several in lower speed and then return to the normal speed. If it
is “Stop”, the machine will stop automatically and the machine will continue
normal embroidery after it is stared again.
Start Sti. no T. B. D.: (Options: 0~15)
This parameter is to decide in how many stitches after patching the
machine won’t check whether there is thread break.
T. B. Detect at Jump: (Options: Yes, No)
This is to decide whether to check thread break during jump stitch in
embroidery.
Long Sti. Divide: (Options: No, 7~12)
This parameter is to decide whether to divide the long stitches in
embroidery and the stitch length in dividing.
If the stitch is too long, the main shaft will reduce its rotation speed. The
longer the stitch is, the lower the speed will be. The machine can divide the
long stitch (longer than the set value) to two or more stitches according to the
set value, and then jump to finish it.
Jump Length: (Options: 4.5, 6.5)
This is to set the division unit length which is used for dividing the long
stitches in embroidery or for dividing the long stitches into jump stitches in
design scaling up/down and rotation. Its measurement unit is mm.
