Part IV Setting Parameters
44 BECS-09 Singular-head Computerized Embroidery Machine
4.7 Standard Embroidery Data Parameter
This is to set the data parameters concerning the standard embroidery.
Their options and default values are shown in the appendix.
Jump to Trim: (Options: No, 1-7)
It is to decide how to deal with the jump stitch codes in the design. When
the parameter is set as “No”, it means jumping and no trim. Otherwise if the
continuous jump stitches are less than the set value, there will be jumping and
no trim; if the continuous stitches are larger than or the same as the set value,
there will be jumping to trim.
When it is jumping and no trim, the machine will jump stitch in case of the
jump stitch codes; if it is jumping to trim, the machine will act as if over-frame,
namely automatic stop, moving frame and automatic start.
Thread broken detect: (Options: 3~7, No)
When this parameter is set as "Yes", the machine will automatically judge
Stain Data Parameter
Jump To Trim:
3 Sti
Thr. Broken Detect:
5
Thr. Brok Sensi:
Low
T. Broken Back Sti
3
Patch Stitch:
5
Treat After Patch:
Normal
Start Sti. no T. B. D. :
8
T. B. Detect at Jump:
No
