Ricoh MP CW2200, User Manual

Page: 183 / 220

Message Status
"Setting change..." The machine is changing settings. You cannot use the control panel
while this message is displayed. Wait a while.
"Waiting for print data..." The machine is waiting for the next data to print. Wait a while.
"Suspending print jobs..." Printing was temporarily suspended because [Job Operation] or the
[Stop] key was pressed.
"Updating certificate..." The @Remote certificate is being updated. Wait a while.
Messages displayed on the control panel when using the printer function
• Before turning the main power switch off, see p.37 "Turning On/Off the Power".
Message Causes Solutions
"Cannot connect with the
wireless card. Turn the main
power switch off, then
check the card." • The wireless LAN board
was not inserted when
the machine was turned
on.
• The wireless LAN board
was pulled out after the
machine was turned on.
• The settings are not
updated although the
unit is detected.
Turn off the main power switch, and
then confirm the wireless LAN board is
inserted correctly. And then, turn on
the main power switch again. If the
message appears again, contact your
service representative.
"Hardware Problem:
Ethernet" An error has occurred in the
Ethernet interface. Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
"Hardware Problem: HDD" An error has occurred in the
hard disk. Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
When Messages Are Displayed on the Control Panel
181