SERVICE PROGRAM MODE
10 August, 2001
4-64
4.2.7 MEMORY ALL CLEAR (SP5-801)
Executing Memory All Clear resets all the settings stored in the NVRAM to their
default settings except the following:
SP7-003-1:
Electrical total counter value
SP5-811-1:
Machine serial number
SP5-907:
Plug & Play Brand Name and Production Name Setting
Normally, this SP mode should not be used. This procedure is necessary only after
replacing the NVRAM, or when the copier malfunctions because the NVRAM is
damaged.
Using a Flash Memory Card
1. Upload the NVRAM data to a flash memory card (
☛
NVRAM Data Upload).
2. Print out all SMC data lists (SP mode 5-990).
NOTE:
Be sure to print out all the lists. If the NVRAM data upload was not
completed, it is necessary to change the SP mode settings by hand.
3. Open SP mode 5-801.
4. Press the number for the item that you want to initialize. The number you select
determines which application is initialized. For example, press 1 if you want to
initialize all modules, or select the appropriate number from the table below.
No.
What It Initializes
Comments
1
All modules
Initializes items 2 ~ 12 below.
2
Engine
Initializes all registration settings for the engine and
process settings.
3
SCS (System Control
Service)/SRAM
Initializes default system settings, CSS settings,
operation display coordinates, and ROM update
information.
5
MCS (Memory Control
Service)
Initializes the automatic delete time setting for
stored documents.
6
Copier application
Initializes all copier application settings.
7
Fax application
Initializes the fax reset time, job login ID, all TX/RX
settings, local storage file numbers, and off-hook
timer.
8
Printer application
Initializes the printer defaults, programs registered,
the printer SP bit switches, and the printer CSS
counter.
9
Scanner application
Initializes the scanner defaults for the scanner and
all the scanner SP modes.
10
Network application
Deletes the network file application management
files and thumbnails, and initializes the job login ID.
11
NCS (Network Control
Service)
Initializes the system defaults and interface settings
(IP addresses also), SmartNetMonitor for Admin,
WebStatusMonitor settings, and the TELNET
settings.
12
R-FAX
Initializes the job login ID, SmartNetMonitor for
Admin, job history, and local storage file numbers.