SERVICE PROGRAM MODE
10 August, 2001
4-62
ARDF Output Check (SP6-008)
1. Open SP mode SP6-008.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table below.)
3.
Press On then press Off to test the selected item. You cannot exit and close
this display until you click Off to switch off the output check currently executing.
No. Description
1
Feed Motor (Forward)
2
Feed Motor (Reverse)
3
Transport Motor (Forward)
4
Feed Clutch
5
Pick-up Solenoid
6
Junction Gate Solenoid
7
Stamp Solenoid
Finisher Output Check (SP6-118)
1. Open SP mode SP6-118.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table below.)
3.
Press On then press Off to test the selected item. You cannot exit and close
this display until you click Off to switch off the output check currently executing.
No.
Description
1000-sheet finisher
500-sheet finisher
1
Upper Transport Motor
Main Motor
2
Shift Tray Lift Motor
Output Tray Motor
3
Staple Hammer Motor
Stapler Motor
4
Shift Motor
Jogger Motor
5
Lower Transport Motor
Not Used
6
Shift Tray Exit Motor
Not Used
7
Tray Junction Gate Solenoid
Not Used
8
Jogger Motor
Not Used
9
Stapler Motor
Not Used
10
Stapler Junction Gate Solenoid
Not Used
11
Positioning Roller Solenoid
Not Used
12
Stack Feed-out Motor
Not Used
13
Exit Guide Plate Motor
Not Used
14
Not Used
Paddle Roller Solenoid
15
Not Used
Exit Unit Gear Solenoid
16
Not Used
Stack Height Lever Solenoid
17