SERVICE PROGRAM MODE
10 August, 2001
4-32
5
Mode Number/Name
Function/[Setting]
Key Counter Up Timing
121*
Determines whether the total counter counts up at
paper feed-in or at paper exit.
[
0 = Feed In
/ 1 = Exit]
APS Mode Setting
127*
Selects whether APS mode is selected as the power-
up default.
[0 = Enable /
1 = Disabled
]
F Paper Size Selection
129*
Selects the “F” paper size.
[0 ~ 2 /
0
/ 1 step]
0: 8" x 13"
1: 8.5" x 13"
2: 8.25" x 13"
Paper Size Type Selection
131*
Selects the paper size (type) for both originals and
copy paper.
[0~2 /
DIP SW setting
/ 1 step]
0: Japan
1: North America
2: Europe
After changing the setting, turn the copier off and on. If
the paper size of the archive files stored on the HDD is
different, abnormal copies could result. Ask the
customer to restore the archive files.
By-Pass Long Paper Mode
150*
Determines whether long paper can be fed from the by-
pass tray.
[0 = Off
, 1 = On]
Normally the paper length from the by-pass tray is
limited to 600 mm, but this can be extended with this
SP to 1260 mm.
Note that, with either setting, the image quality can only
be guaranteed for 432 mm.
Page Stamp
3
Duplex Printout
Right/Left Position
Determines how horizontal printing is executed during
duplex printing. Set the upper right corner of the front
side and the upper left corner of the back side so the
starting points for horizontal printing are the same on
both sides
DFU.
[–10~+10 /
0
/ 1 mm step]
–10:
Extreme right
+10:
Extreme left
212*
4*
Duplex Printout
High/Low Position
Determines how vertical printing is executed during
duplex printing. Set the upper right corner of the front
side and the upper left corner of the back side so the
starting points for vertical printing are the same on both
sides.
DFU
[–10~+10 /
0
/ 1 mm step]
–10:
Extreme top
+10:
Extreme bottom