ERROR CODES
21 December, 2001
2-2
Code
Meaning
Suggested Cause/Action
0-06
The other terminal did not
reply to DCS
•
Check the line connection.
•
Check the FCU - NCU connectors.
•
Try adjusting the tx level and/or cable equalizer
settings.
•
Replace the NCU or FCU.
•
The other end may be defective or incompatible;
try sending to another machine.
•
Check for line problems.
Cross reference
•
See error code 0-04.
0-07
No post-message response
from the other end after a
page was sent
•
Check the line connection.
•
Check the FCU - NCU connectors.
•
Replace the NCU or FCU.
•
The other end may have jammed or run out of
paper.
•
The other end user may have disconnected the
call.
•
Check for a bad line.
•
The other end may be defective; try sending to
another machine.
0-08
The other end sent RTN or
PIN after receiving a page,
because there were too
many errors
•
Check the line connection.
•
Check the FCU - NCU connectors.
•
Replace the NCU or FCU.
•
The other end may have jammed, or run out of
paper or memory space.
•
Try adjusting the tx level and/or cable equalizer
settings.
•
The other end may have a defective
modem/NCU/FCU; try sending to another
machine.
•
Check for line problems and noise.
Cross reference
•
Tx level - NCU Parameter 01 (PSTN)
•
Cable equalizer - G3 Switch 07 (PSTN)
•
Dedicated Tx parameters - Section 4
0-14
Non-standard post message
response code received
•
Check the FCU - NCU connectors.
•
Incompatible or defective remote terminal; try
sending to another machine.
•
Noisy line: resend.
•
Try adjusting the tx level and/or cable equalizer
settings.
•
Replace the NCU or FCU.
Cross reference
•
See error code 0-08.
