21 December, 2001
BIT SWITCHES
3-37
Service
Tables
Communication Switch 0F
- Not used (do not change the settings.)
Communication Switch 10
SP No. 1-104-017
No
FUNCTION
COMMENTS
0
to
7
Memory transmission:
Maximum number of dialing
attempts to the same
destination
01 - FE (Hex) times
Communication Switch 11
- Not used (do not change the settings.)
Communication Switch 12
SP No. 1-104-019
No
FUNCTION
COMMENTS
0
to
7
Memory transmission: Interval
between dialing attempts to the
same destination
01 - FF (Hex) minutes
Communication Switch 13
- Not used (do not change the settings.)
Communication Switch 14
SP No. 1-104-021
No
FUNCTION
COMMENTS
0
Inch-to-mm conversion during
transmission
0:
Disabled
1:
Enabled
0:
In immediate transmission, data scanned in inch
format are transmitted without conversion.
In memory transmission, data stored in the SAF
memory in mm format are transmitted without
conversion.
Note:
When storing the scanned data into SAF
memory, the fax unit always converts the data
into mm format.
1:
The machine converts the scanned data or stored
data in the SAF memory to the format which was
specified in the set-up protocol (DIS/NSF) before
transmission.
1-5
Not used
Do not change the factory settings.
6
to
7
Available unit of resolution in
which fax messages are
received
Bit 7
Bit 6
Unit
0
0
mm
0
1
inch
1
0
mm and inch
(default)
1
1
Not used
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to
the transmitting terminal in the pre-message
protocol exchange (in the DIS/NSF frames).
Communication Switch 15
- Not used (do not change the settings)
