BIT SWITCHES
21 December, 2001
3-14
System Switch 09
SP No. 1-101-010
No
FUNCTION
COMMENTS
0
Addition of image data from
confidential transmissions on
the transmission result report
0:
Disabled
1:
Enabled
If this feature is enabled, the top half of the first
page of confidential messages will be printed on
transmission result reports.
1
Inclusion of communications on
the Journal when no image
data was exchanged.
0:
Disabled
1:
Enabled
0:
Communications that reached phase C (message
tx/rx) of the T.30 protocol are listed on the
Journal.
1:
Communications that reached phase A (call
setup) of T.30 protocol are listed on the Journal.
This will include telephone calls.
2
Automatic error report printout
0:
Disabled
1:
Enabled
0:
Error reports will not be printed.
1:
Error reports will be printed automatically after
failed communications.
3
Printing of the error code on the
error report
0:
No
1:
Yes
1:
Error codes are printed on the error reports.
4
Not used
Do not change the settings.
5
Power failure report
0:
Disabled
1:
Enabled
1:
A power failure report will be automatically printed
after the power is switched on if a fax message
disappeared from the memory when the power
was turned off last.
6
Conditions for printing the
protocol dump list
0:
Print for all communications
1:
Print only when there is a
communication error
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1:
Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
7
Priority given to various types
of remote terminal ID when
printing reports
0:
RTI > CSI > Dial label > Tel.
number
1:
Dial label > Tel. number >
RTI > CSI
This bit determines which set of priorities the
machine uses when listing remote terminal names
on reports.
In G4 communication, G4_TID (Terminal ID) is used
instead of RTI or CSI.
Dial Label:
The name stored, by the user, for the
Quick/Speed Dial number.
