Ricoh FT5034, Service Manual

Page: 4 / 139

1.1 INSTALLATION REQUIREMENTS
The installation location should be carefully chosen because environmental
conditions greatly affect the performance of a copier.
1. Environments to Avoid
•
Avoid any area exposed to direct sunlight or strong light (Illumination must be
less than 1500 Lux).
•
Avoid any area exposed to extremes of temperature and humidity (standard
condition: 10°C ~ 30°C, 15% ~ 90%).
•
Avoid any area exposed to heated air from a heater.
•
Avoid any area where temperature suddenly changes from low to high or vice
versa.
•
Avoid placing the copier in an area filled with dust, and subjected to frequent
strong vibration.
•
Avoid narrow space (10 m
3
).
2. Access to Copier
Place the copier near a power source, providing clearance as shown. The copier
must be level within 5 mm both front to rear and left to right.
3. Power Connection
•
Input voltage level:
220 V/50 Hz, more than 10 A
•
Avoid connecting the power cord
to a socket that already has
power cords attached
•
Permissible voltage fluctuation:
220 V (
±
10%)
•
Avoid using a power cord
extension. If you must use one,
make sure that it can carry 250
V, 10 A and that it is less than 5
m long.
4. Earth Connection
•
Be sure to ground the machine properly.
•
Do not connect the grounding wire to a gas pipe.
more than 10 cm
more than 80 cm
more than
50 cm
more than
70 cm
Front
- 3 -