2. 1st and 2nd Feed Stations
1) Remove the feed roller and hub (1
snap ring).
NOTE: When reinstalling the feed
roller, make sure that the hub
is positioned toward the rear
on the shaft.
2) Remove the cassette arm (2 screws).
3) Mark the position of the eccentric cam
groove on the friction pad holder.
4) Remove the friction pad holder (1
screw and 1 eccentric cam).
5) Peel off the friction pad and stick a new
pad on the friction pad holder.
NOTE: Check that the friction pad is 0.05
to 0.35 mm below the surface of
the front lip.
6) Clean and grease the swivel surface of
the friction pad holder with Mobil Temp 78.
7) Reinstall the friction pad holder.
NOTE: Be sure the legs of the friction pad holder are positioned under the
spring loaded pad positioning mechanism.
The eccentric cam should be secured in the original position
referring to the mark made in step 3).
4. F/L Feed Station
1. Pull out the F/L tray and remove the A3
cassette.
2. Remove the screw securing the feed roller
bracket.
3. Remove the F/L feed roller (1 snap ring).
NOTE: When reinstalling the feed roller,
make sure that the hub is
positioned toward the front on the
shaft.
4. Remove the friction pad assembly (1
stepped screw).
Friction Pad
Pad Positioning
Mechanism
Eccentric
Cam
Friction
Pad Holder
MT78
Hub
Feed Roller
Cassette Arm
A = 0.05 ~ 0.35 mm
(Front)
Friction Pad
Assembly
Hub
Feed Roller
Feed Roller
Bracket
- 25 -
Summary of Contents for FT5034
