11. Run the scanner drive wire over the pulleys in the following order.
1) Attach the tension spring to the short end eyelet and hook the other end of
spring to the cut out in the optics frame temporarily.
2) Set the bead of the scanner drive wire in the holes in the 2nd scanner drive
pulley with the short end located at the lower side (WP1).
3) Two and half turns (WP1)
4) Outer track (WP2)
5) Lower side (Wire Clamp)
6) Lower track (WP3)
7) Inner track (WP4)
8) Three and half turns from lower to upper (Scanner Drive Pulley)
9) Outer track (WP4)
10) Lower track (WP5)
11) Inner track (WP2)
12) Outer track (WP6)
12. Set the long end eyelet in the hook of the tension spring.
13. Reset the damper wheel.
14. Rotate the scanner drive pulley and make sure that the scanner drive wire moves
smoothly and that there is no overlapping on the scanner drive pulley.
Scanner Drive Pulley
7)
5)
4)
3)
10)
8)
6)
9)
11)
Bead
2) Long End
1) Short End
WP4
Damper Wheel
WP1
WP2
(2nd Scanner Pulley)
WP5
WP6
WP3
Wire Clamp
- 39 -
Summary of Contents for FT5034
