Ricoh Aficio FT4027, Service Manual

Page: 36 / 685

28. Pull out the paper tray and load paper into it. (The paper size and direction for
each tray should be as specified by the customer.)
NOTE: The side and rear fences should be properly positioned.
29. Select the appropriate paper size for the paper trays in the main body by
sliding the paper size slider into the correct position (see section 2.3.2 "Paper
size selection for the copier paper trays" for details).
30. When a paper tray unit is installed: Enter the proper paper size for each
paper tray by following the procedure shown in section 2.3, "Paper Size
Selection" and in "Service Tables - SP5-019: Paper Size Setting".
31. Load paper into the paper trays and the copy tray.
32. Attach the appropriate paper size decals [A] to the paper trays.
Also (A156/A160 copiers only), attach the duplex decal to the duplex tray.
NOTE: Paper size decals are used also for the paper tray unit. Save the
remaining decals for use with the paper tray unit.
33. Install the optional platen cover [B] as follows if necessary:
1) Install 2 stud screws [C] on the top cover as shown.
2) Position the platen cover bracket [D] on the stud screws and slide it to the
left.
34. All models except the A156: Attach the symbol explanation decal [E] to the
top cover as shown. (If the ARDF will be installed, stick the decal on the
ARDF exit cover. Refer to the ARDF installation procedure.)
35. Check the copy quality and machine operation.
[C]
[B]
[D]
[E]
[A]
On the paper tray
On the duplex tray
FT5535/4527/4522 3-12 FSM