Ricoh Aficio FT4027, Service Manual

Page: 255 / 685

2.3 ELECTRICAL COMPONENT DESCRIPTION
Refer to the electrical component layout on the reverse side of the Point to Point
Diagram (on waterproof paper).
Symbol
Index
No.
Description Note
Motors
M1
5 Main Drives all the components of the paper tray
M2 2 Tray lift 1
Raises the bottom plate in the paper tray
M3 30 Tray lift 2
M4 29 Tray lift 3 (A549 only)
Circuit board
PCB1 1 Interface board
Controls the paper tray in response to signals
from the copier
Sensors
S1
7 Tray upper limit 1
Detects the top of the stack to stop the tray lift
motor
S2 18 Tray upper limit 2
S3 19
Tray upper limit 3 (A549
only)
S4 25 Relay 1 Detects the leading edge of the paper as it
leaves the tray to control pick-up solenoid and
jam detection timing
S5 23 Relay 2
S6 20 Relay 3
S7 28 Paper end 1
Detects when the paper tray is empty
S8 24 Paper end 2
S9 21 Paper end 3 (A549 only)
Switches
SW1 22 Tray cover
Detects whether the tray unit cover is open and
cuts the 24 Vdc power if it is
SW2 3 Tray set 1
Detects whether the paper tray is in place
SW3 4 Tray set 2
SW4 6 Tray set 3 (A549 only)
Magnetic clutches
CL1
9 Paper feed 1
Starts feeding paper from the tray
CL2 12 Paper feed 2
CL3 15 Paper feed 3 (A549 only)
CL4 11 Relay Drives the rollers in the paper trays
Solenoids
SOL1
8 Paper pick-up 1
Lifts/drops the pick-up roller
SOL2 13 Paper pick-up 2
SOL3 16
Paper pick-up 3 (A549
only)
SOL4 10 Separation 1
Lifts/drops the separation roller
SOL5 14 Separation 2
SOL6 17 Separation 3
Heaters
H1
26 Tray (Option) Turns on when the main switch is off to keep the
paper in the trays dry
H2 27 Tray (Option)
FT5535/4527/4522 8-4 FSM