Ricoh Aficio FT4027, Service Manual

Page: 258 / 685

3. Set the copier [B] on the paper tray unit [C]. Align the 2 pins [D] on the paper
tray unit with the holes in the base plate of the copier.
4. Open the lower door [E]. Also, open either the LCT [F] or the upper right door
[F], whichever is present (depending on the type of copier).
5. Secure the copier to the paper tray unit with the joint bracket [G].
6. Remove the Plug [P] from the rear of the copier.
7. Connect the cable [H] and optic fiber [I].
8. Attach the support brackets [J] to the bottom of the paper tray unit as shown
(4 screws).
CAUTION
If you do not do this, the machine may fall forwards if all the paper trays
are pulled open.
9. Pull out the paper tray and load paper into it. (The paper size and direction for
each tray should be designated by a customer.)
The side and rear fences should be properly positioned.
10. Turn on the main switch.
11. Enter the proper paper size for each paper tray by following the instructions in
the copier’s manual.
12. Attach the appropriate tray decals [K] which are included in the accessory
box of the main copier.
13. Check the machine’s operation and copy quality.
Rev. 10/11/95
⇒
[B]
[D]
[F]
[I]
[H]
[D]
[G]
[E]
[C]
For Copiers with an LCT: Do not lift the
copier by holding the LCT unit.
[J]
[K]
⇒
Fiber Connector Plug [P]
FSM 8-7 FT5535/4527/4522