Ricoh Aficio 2090, Network Manual

Page: 85 / 126

Remote Maintenance by telnet
77
9
*1
IP address
SLP
Use this command to configure SLP
settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. To use the slp
command, you can configure the val-
ue of TTL that can be used by the SLP
multi-cast-packet.
Note
❒
The default value of TTL is “1”. A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒
The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
Setting IEEE 802.11b
Use the wiconfig command to config-
ure IEEE 802.11b settings.
Limitation
❒
You can make settings when in-
stalling the optional 802.11b inter-
face kit.
❖ ❖ ❖ ❖
View settings
The following command displays
the current IEEE 802.11b settings.
msh> wiconfig
The IEEE 802.11b card information
is displayed.
msh> wiconfig cardinfo
Note
❒
If the IEEE 802.11b interface is
not working correctly, the IEEE
802.11b card information is not
displayed.
❖
❖ ❖
❖
Configuration
route de-
lete {host |
net} desti-
nation
*1
Deletes a host/network route
from the table. Host becomes
the default.
route get
{destina-
tion
*1
}
Displays only route informa-
tion corresponding to a spec-
ified destination. When the
destination is unspecified, all
routing information is dis-
played.
route active
{host | net}
destination
*1
on/off
You can turn the specified
destination on or off. Host be-
comes the default.
route add
default
gateway
*1
You can set the default gate-
way address.
route flush Deletes all routing informa-
tion.
Commands Topics of setting
Parameter Value to be con-
figured
mode
[ap|802.11adhoc|
adhoc] You can set Infra-
structure mode
(ap), 802.11 Ad hoc
mode
(802.11adhoc) or
Ad hoc mode (ad-
hoc).
The default is
802.11 Ad hoc
mode.