Ricoh Aficio 2090, Network Manual

Page: 35 / 126

27
4. Windows Configuration
Configuring TCP/IP
Follow these instructions to configure
Windows to use TCP/IP and IPP.
Configuring a Windows
95/98/Me computer
These steps are for configuring a Win-
dows 95/98/Me computer to use
TCP/IP.
AAAA
Open [ Control Panel ] , and then
double-click the [ Network ] icon.
Make sure that TCP/IP is listed in
the
[ The following network compo-
nents are installed ] box on the [ Con-
figuration ] tab.
Note
❒
Under Windows Me, if you
want to use IEEE 1394 (IP over
1394) interface, make sure TCP/
IP is bound to the IEEE 1394
adaptor being used. The follow-
ing message will be displayed:
TCP/ IP -> (IEEE 1394
adaptor in use)
❒
If TCP/IP is not installed, click
[ Add ]
on the
[ Configuration ]
tab to
install it. For more information
about installing TCP/IP, see
Windows 95/98/Me Help.
BBBB
Configure TCP/IP with the appro-
priate IP address, subnet mask
and other settings.
Check with the network adminis-
trator that the settings are correct.
Configuring a Windows 2000
computer
These steps are for configuring a Win-
dows 2000 computer to use TCP/IP.
AAAA
Click the [ Start ] button on the task-
bar, point to [ Settings ] , and then
click [ Network and Dial-up Connec-
tions ]
.
BBBB
Double-click [ Local Area Connec-
tion ] . On the [ General ] tab, click
[ Properties ]
.
CCCC
Make sure that Internet Protocol
(TCP/IP) is selected in the
[ Compo-
nents checked are used by this connec-
tion
] box on the [ General ] tab.
Note
❒
Select TCP/IP if it is not already
selected.
❒
If TCP/IP is not installed, click
[ Install ] on the [ General ] tab to in-
stall it. For more information
about installing TCP/IP, see
Windows 2000 Help.
DDDD
Configure TCP/IP with the appro-
priate IP address, subnet mask
and other settings.
Check with the network adminis-
trator that the settings are correct.