Ricoh Aficio 2090, Network Manual

Page: 32 / 126

Setting Up the Machine on a Network
24
3
❖ ❖ ❖ ❖
SCSI print (SBP-2)
When you print using the SCSI
Print client function supported by
Windows 2000 or Windows XP,
you must set SCSI Print.
Note
❒
Default: Active
❖
❖ ❖
❖
Bidirectional SCSI print
Specifies the printer's response
mode and so forth for a status re-
quest when using the IEEE 1394 in-
terface.
Note
❒
Default: ON
❒
If this is set to “OFF”, bidirec-
tional communication functions
will not work.
❖ ❖ ❖ ❖
Host Name
Specify the host name.
❖
❖ ❖
❖
Domain Name
Specify the domain name.
Interface Settings/IEEE 802.11b
Preparation
You must install the wireless LAN
board (optional) into the machine.
Note
❒
Be sure to make all settings simul-
taneously.
❖ ❖ ❖ ❖
Communication Mode
Specifies the communication mode
of the Wireless LAN.
Note
❒
Default: 802.11 Ad hoc
❖ ❖ ❖ ❖
SSID Setting
Specifies SSID to distinguish the
access point in the Infrastructure
mode.
Note
❒
Default: blank (ASSID)
❒
The characters that can be used
are ASCII 0x20- 0x7e (32 bytes).
❒
If blank is specified in 802.11b
Ad hoc mode or Ad hoc mode,
“ASSID” appears.
❖
❖ ❖
❖
Channel
Specifies a channel when you se-
lect 802.11b Ad hoc mode or Ad
hoc mode.
Note
❒
Default: 11
❒
The channel can be set from fol-
lowing channel:
• Metric Version: 1-13
• Inch Version: 1-11
❖
❖ ❖
❖
Wireless LAN Signal
Shows the radio wave conditions
of the access point connected in In-
frastructure mode.
Note
❒
Radio wave status is shown
when you press the
[ Wireless
LAN Signal ] key.
❖ ❖ ❖ ❖
WEP (Encryption) Setting
Specifies the encryption of the
Wireless LAN. If this is set to “Ac-
tive”, you must enter the WEP key.
Note
❒
Default: Inactive