C O M M A N D L I N E I N T E R F A C E
Commands
350-9047 v3.0.1
DGy Model 201x User’s Guide
93
. . . . .
. . . . . . . . .
INPUT COMMANDS
The table below lists all
DGy 201x
input commands, their arguments and
detailed descriptions.
Table 6-2
Input Commands
Command
Arguments
Description
IN
put
A
uto
S
ync
<AUTO | LOCK |
DEBUG>
AUTO engages the input autosync circuitry. LOCK
turns the autosync circuitry off. If the source is
slightly unstable this prevents the autosync circuitry
from constantly re-acquiring the signal. DEBUG
provides information on input status, and reports
changes to measured parameters (serial port only).
Default: AUTO
INputFormat
(none)
INputFormat is a read only command that reports
the type of signal selected for recording.
IN
put
LOAD
<1..160>
Loads the indicated entry from the Timing List to
the RGB input channel.
This command only operates when an analog RGB
signal is present and selected (with the
INputSouRCe
command). Otherwise an error
message will be returned.
Refer to the
Factory Timing List
section for
additional details.
IN
put
MOD
ulus
(none)
This command provides a way to optimize the input
timing for the analog RGB input to exactly sample
the center of each pixel.
A reasonably busy image is required for alignment
(for example a screen with fine vertical lines or a
screen with lots of fine text). After issuing the
command the following letters may be pressed to
make changes.
i = increase modulus
m =decrease modulus
j = decrease phase
l= increase phase
J = move left
L = move right
I = move up
M = move down
Note
: these are case sensitive.
With the image properly adjusted, quit the utility:
q = quit
If the timing of the analog source is known, it should
be entered with the
INputTiMing
command, but the
INputMODulus command may still be used to set
the sampling phase interactively.
