TE C H N I C A L S P E C I F I C A T I O N S
Connectors and Pinouts
350-9047 v3.0.1
DGy Model 201x User’s Guide
128
. . . . .
O U T P U T C A B L E S
Both the digital and analog outputs of the
DGy 201x
are provided on the
graphics output connector. Purpose built cables are available
commercially to provide connections for digital interfaces or analog
interfaces. The
DGy 201x
is provided with DVI 15-pin adapters for use
with analog devices, or alternatively an analog only output cable can be
purchased that provides a “break out” capability to separate RGB
connectors or sub miniature 15-pin D connector.
ETHERNET
. . . . . . . . .
CONNECTOR
C O N N E C T O R T Y P E A N D P I N O U T S
The Ethernet connector is a standard RJ-45 type connector.
Figure A-2
Ethernet Connector
The 8-pin RJ-45 Ethernet connector has the following signals:.
S T A N D A R D C A B L E S
Standard Ethernet cables are available commercially in many different
lengths. The standard cable is wired pin-for-pin (straight through) which
means that pin 1 of the connector at one end of the cable is wired to pin
1 of the connector at the opposite end of the cable. This type of cable is
used to connect the
DGy 201x
directly to the network — typically using
an Ethernet hub or switch. To connect directly from a PC to the
DGy
201x
, a crossover cable must be used (see the following section for
details).
Table A-11
Ethernet Connector Pinouts (EIA/TIA 568B)
Pin
Signal
Wire Color
1
TX Data +
White/Orange
2
TX Data -
Orange
3
RX Data+
White/Green
4
Blue
5
White/Blue
6
RX Data-
Green
7
White/Brown
8
Brown