Renogy Off-Grid Kit, General Manual

Page: 54 / 75

54
Slide panel onto brackets and fasten with end lamps
A. Hold the panel up to the pole mount to determine approximate position that End Clamps
(J) must be to hold panel.
B. Start with the bottom clamps since they will hold most of the load.
C. Slide a T-Bolt (F) through T-Slotted Bracket (A) to the appropriate location.
D. Orient the clamps as they are in Figure 6 .
E. Once End Clamps (J) and in a position to hold the panel, slide the panel onto the bracket,
slide the End Clamp over the edge of the panel so that the surfaces are flush as shown in
Figure 7 .
F. Fasten the End Clamp with a Nut (K) and Washer (H).
G. Repeat for the other bottom End Clamp, followed by the two top End Clamps.
Figure 6
NOTE:
This is what the clamp should look like when it is fastened to the panel. Also note
that the thread length may not be as long as shown, but will still work.
J