61
d) Mounting of the dome
Mounting the holding blocks
2x holding blocks
2x cylinder head screws M3x25
2x slot nuts M3
Insert one slot nut into each of the upper aluminium profiles. The slot
nuts must be at a distance of only a few millimetres from the front.
Insert one of the cylinder head screws through each holding block and
tighten it in one of the two slot nuts inserted previously. Align both hol-
ding blocks in such a way that they make contact with the front profile
and the sloped side is pointed towards the front side.
Attaching the dome
Place the assembled dome onto your printer. Guide the filament hose
through the cut-out on the side. The back of the dome must make
contact with the housing and its front with the two holding blocks. If
necessary, correct the position of the two holding blocks.
The housing is now completely assembled.
If you have not removed the protective films during assembly, you
should remove all of them now.
