32
Position the printer so that the rear
right
aluminium profile is acces
-
sible.
Release and remove the 4 M5 cylinder-head screws that attach the
profile.
Take the aluminium profile attached across from the filament holder
and put it aside.
Put the other profile, where the Z-motor is attached, aside as well.
Remove das vertical aluminium profile from the printer.
Remove the foot from the disassembled aluminium profile and put it
aside.
Carefully lever the ball bearing out of the cut-out of the short profile
and insert it into the long aluminium profile.
The short profile with the cut-out is no longer needed.
The upper bores and cut-outs of the long and short alu-
minium profiles are identical!
Insert the long aluminium profile into the printer and attach it at the top
with 2 of the 4 M5 cylinder-head screws.
Tighten the screws hand-tight.
Take the foot and screw it into the aluminium profile at the bottom.
Insert the aluminium profile that belongs opposite the filament holder
into the printer and attach it with one M5 cylinder-head screw.
Tighten the screw hand-tight.
The bore in the middle of the profile must be vertical. The milled sides
of the bore must point down.
