56
Explanations for assembly
During the assembly, always insert all screw
nuts into the slits of the cut-outs.
The even surface of the screw nut must al-
ways be inside the cut-out and the tip of the
nut must always point outwards.
Then put both pieces together.
The noses of one part must be inserted into
the corresponding cut-out of the other part.
Finally, screw all M3 cylinder head screws
through the boreholes of the respective se-
cond part into the nuts inserted previously.
Tighten all cylinder head screws slightly at first so that nothing can move. Tighten all screws well only at the end when the entire
dome is assembled.
However, do not tighten the screws too much since the plastic might break or crack otherwise.
Assembly of the dome
1x back plate
A3
1x side plate
A4
2x cylinder head screws M3x12
2x screw nuts M3
Please note! The screws and nuts are depicted slightly
bigger.
Insert the two screw nuts into the slits inside the cut-outs. Remove the
protective film on both sides around the 2 boreholes of the rear plate
and around the two noses of the side plate.
Fasten the side plate with the two M3 cylinder head screws to the rear
plate as shown in the two pictures.
