16
e) Conversion of the mains unit
Take the original mains unit and remove the green connection plug.
The mains unit and the two wire jumpers are no longer needed.
1 x mains unit new from the set
1 x connection plug from the main PCB (green)
The white lines of the mains unit are plus, the black ones are minus.
Now connect the white double line of the mains unit to the left terminal
of the plug.
The 2nd
terminal from the left holds the black double line
of the mains unit.
The 3rd
terminal must have the remaining white line connected; the
remaining black line is connected to the far right.
If you have only acquired the set for the heated printing plate, now
connect the mains unit to the green plug of the main PCB again.
Oth-
erwise, skip this item.
Observe the corresponding chapter in the main instructions.
