37
Attachment of the table to the flange nut
Push the undertable upwards manually and turn the flange nut up
until you can turn in the screws from below.
Put the undertable down on the flange nut and align it. The flat side
must point backwards.
Attach the flange nut with the two cylinder-head screws M4x16 mm
at the undertable.
Tighten the screws.
Relief of the printer
Before attaching the remaining components to the printer again, relieve it completely first.
Release all M5 cylinder-head screws that attach the 4 vertical aluminium profiles to the transverse profiles for this. You only need to
release the screws until the profiles are loose. Also loosen the 4 screws with which the X-guide rail is attached to the guide carriage
plates.
Then tighten all M5 cylinder-head screws slightly first, then hand-tight, and finally very tightly in sequence. Guide or hold the alu
-
minium profiles with your fingers so that they run in one line.
When all M5-screws are tight, tighten the 4 screws of the X-guide rail again.
