Renesas PLSP0020JB-A, User Manual

Page: 220 / 341

R8C/1A Group, R8C/1B Group 16. Clock Synchronous Serial Interface
Rev.1.30 Dec 08, 2006 Page 202 of 315
REJ09B0252-0130
Figure 16.24 ICCR1 Register
IIC bus Control Register 1
(6)
Symbol Address After Reset
ICCR1
00B8h 00h
Bit Symbol Bit Name Function RW
NOTES :
1.
2.
3.
4.
5.
6.
Master/slave select bit
(5)
In master mode w ith the I
2
C bus format, w hen arbitration is lost, bits MST and TRS are set to 0
and the IIC enters slave receive mode.
When an overrun error occurs in master receive mode of the clock synchronous serial format, the MST bit
is set to 0 and the IIC enters slave receive mode.
b0
Rew rite the TRS bit betw een transfer frames.
RCVD
Receive disable bit After reading the ICDRR register w hile the TRS bit
is set to 0.
0 : Maintains the next receive operation.
1 : Disables the next receive operation.
RW
b3 b2
RW
RW
b1 b7 b6 b5 b4
CKS2
CKS3
CKS0
CKS1
RW
TRS
Transmit clock select bits 3 to
0
(1)
b3 b2 b1 b0
0 0 0 0 : f1/28
0 0 0 1 : f1/40
0 0 1 0 : f1/48
0 0 1 1 : f1/64
0 1 0 0 : f1/80
0 1 0 1 : f1/100
0 1 1 0 : f1/112
0 1 1 1 : f1/128
1 0 0 0 : f1/56
1 0 0 1 : f1/80
1 0 1 0 : f1/96
1 0 1 1 : f1/128
1 1 0 0 : f1/160
1 1 0 1 : f1/200
1 1 1 0 : f1/224
1 1 1 1 : f1/256
b5 b4
0 0 : Slave receive mode
(4)
0 1 : Slave transmit mode
1 0 : Master receive mode
1 1 : Master transmit mode
RW
MST RW
RW
Transfer/receive select bit
(2, 3)
Refer to
16.3.8.1 Accessing of Registers Associated w ith I
2
C bus Interface
for more information.
When the first 7 bits after the start condition in slave receive mode match w ith the slave address set in the SAR
register and the 8th bit is set to 1, the TRS bit is set to 1.
RW ICE
IIC bus interface enable bit 0 : This module is halted.
(Pins SCL and SDA are set to port function.)
1 : This module is enabled for transfer
operations.
(Pins SCL and SDA are bus drive state.)
Set according to the necessary transfer rate in master mode. Refer to Table 16.6 Transfer
Rate Exam ples
for the transfer rate. This bit is used for maintaining of the setup time in transmit mode of slave
mode. The time is 10Tcyc w hen the CKS3 bit is set to 0 and 20Tcyc w hen the CKS3 bit is set to 1. (1Tcyc = 1/f1(s))