rev04
11
10. SERVICE MODE
If you are using the transmitter in Main-libre mode and you need to have your vehicle serviced but you prefer not to leave the transmitter
with it, this quicker procedure will allow you to temporarily disable automatic arming/disarming and the anti-hijack function without entering
the selection procedure (Service set-up).
Turn ignition on and press push-button n. 2 of the transmitter.
Ä
The system sets itself to service mode. This is con
fi
rmed by a short sharp
audible signal.
The Main-libre operation mode will be reinstated the
fi
rst time push-button n. 1 is pressed again. In the meantime you will hear four short
sharp audible reminder signals every time ignition is turned off.
11. ADJUSTMENT OF MOVEMENT DETECTION SENSITIVITY
The movement detector can be adjusted to 8 different levels of sensitivity to displa 8 different levels of sensitivity to shock. Normally
it is
fi
ne-tuned for optimal performance by the installer during the
fi
nal testing, but the procedure is simple and sensitivity can be modi
fi
ed
by the user if required.
1. While the system is disarmed, turn ignition on.
Ä
20 s later the LED lights up and remains on for 3 s.
2. During this lapse of time, press push-button n. 1 of the transmitter.
Ä
A sharp audible signal con
fi
rms you have
entered the procedure
of adjustment of the sensitivity to displacement
(e.g. towing / lifting).
3. Press push-button n. 1 to increase sensitivity.
Ä
A short sharp audible signal con
fi
rms the success of the operation.
Press push-button n. 2 to decrease sensitivity.
Ä
A short deep audible signal con
fi
rms the success of the operation.
The minimum and the maximum sensitivity levels are signalled by 3 audible signals in sequence.
4. Once the appropriate sensitivity level has been selected, turn ignition off, then turn it on immediately again.
Ä
A deep audible signal
con
fi
rms you have
entered the procedure of adjustment of the sensitivity to shock.
5. Operate as described at pos. 3).
6. Once the appropriate sensitivity level has been selected, turn ignition off.
Ä
A sharp audible signal con
fi
rms you have quit the selection
procedure.
To test the movement sensor and determine the optimal sensitivity level more easily, you can simulate displacement / shock before quitting
the procedure; if the sensitivity is suf
fi
cient to trigger the unit, you will get a sharp audible signal (instead of a full alarm cycle).
Remarks:
• To ensure accurate adjustment, avoid generating shocks while selecting the level of sensitivity to displacement.
• It is recommended to evaluate the optimal sensitivity levels once both adjustments have been set, before quitting the procedure.
Operating instructions
