Renault ALASKAN 2020, Vehicle User Manual

Page: 248 / 334

CAUTION
When storing the wheel, be sure to mount the
wheel horizontally. Securing a wheel that is in a
tilted position as illustrated may cause looseness
and dropping of the wheel while driving. Lower
the wheel on to the ground again, and make sure
that the hanging plate is properly set. Hang the
wheel again and make sure that the wheel is held
horizontally, then store the wheel.
Blocking wheels
WARNING
Be sure to block the appropriate wheel to prevent
the vehicle from moving, which may cause per-
sonal injury.
Place suitable blocks
➀
at both the front and back
of the wheel diagonally opposite the flat tyre
j
A to
prevent the vehicle from moving when it is jacked
up.
Removing tyre
WARNING
•
Be sure to read and follow the instructions in
this section.
•
DO NOT GET UNDER A VEHICLE THAT IS SUP-
PORTED BY A JACK.
•
Never use a jack which was not provided with
your vehicle.
•
The jack, which is provided with your vehicle,
is designed only to lift your vehicle during a
tyre change.
•
Never jack up the vehicle at a location other
than the jack-up point that is specified.
•
Never lift the vehicle more than necessary.
•
Never use blocks on or under the jack.
•
Never start or run the engine while the vehicle
is on the jack. The vehicle may move suddenly,
and this may cause an accident.
•
Never allow passengers to remain in the ve-
hicle while the tyre is off the ground.
•
Be sure to read the caution label attached to
the jack body before using.
Removing the wheel cap (where fitted):
Remove the centre wheel cap
➀
as illustrated.
SCE0982Z
MCE0001DZ
SCE0139HZ
240
In case of emergency