Renault ALASKAN 2020, Vehicle User Manual

Page: 219 / 334

System fault
This message is displayed when the Stop/Start Sys-
tem is malfunctioning.
Have the system checked by an approved dealer or
qualified workshop.
STOP/START OFF SWITCH
The system can be temporarily deactivated by
pressing the Stop/Start OFF switch. Pressing the
switch again or restarting the engine by using the
ignition switch will reactivate the Stop/Start Sys-
tem.
•
When the Stop/Start System is deactivated
while the engine is running, the engine is pre-
vented from automatically stopping.
•
When the Stop/Start System is deactivated af-
ter the engine has been automatically stopped
by the Stop/Start System, the engine will imme-
diately restart if suitable conditions are present.
The engine will then be prevented from auto-
matically stopping during the same journey.
•
Whenever the Stop/Start System is deactivated
the indicator light
➀
on the Stop/Start OFF
switch illuminates. In this condition the Stop/
Start System cannot prevent unnecessary fuel
consumption, exhaust emissions, or noise dur-
ing your journey.
•
If the Stop/Start System is malfunctioning, the
indicator light
➀
on the Stop/Start OFF switch
illuminates.
NOTE
The Stop/Start System ON or OFF messages dis-
played for a few seconds in the vehicle informa-
tion display when the Stop/Start OFF switch is
pressed. See “Stop/Start System display” earlier
in this section.
WARNING
•
Do not attempt to raise two wheels off the
ground and shift the transmission to any drive
or reverse position with the engine running.
Doing so may result in drivetrain damage or
unexpected vehicle movement which could
result in serious vehicle damage or personal
injury.
•
Do not attempt to test a 4WD equipped ve-
hicle on a 2-wheel dynamometer or similar
equipment even if the other two wheels are
raised off the ground. Make sure you inform
test facility personnel that your vehicle is
equipped with 4WD before it is placed on a dy-
namometer. Using the wrong test equipment
may result in drivetrain damage or unex-
pected vehicle movement which could result
in serious vehicle damage or personal injury.
CAUTION
•
Do not drive the vehicle in the <4H> or <4LO>
position on dry hard surface roads. Driving on
dry, hard surfaces in <4H> or <4LO> may cause
unnecessary noise, tyre wear and increased
fuel consumption.
If the Four-Wheel Drive (4WD) warning light
turns on when driving on dry hard surface
roads:
– in the <4H> position, shift the 4WD mode
switch to <2WD>.
JVS0346XZ
NSD710
FOUR-WHEEL DRIVE (4WD)
(where fitted)
Starting and driving
211