Renault ALASKAN 2020, Vehicle User Manual

Page: 234 / 334

Changing a cruising speed
Use any one of the following methods to change
the cruising speed.
Resetting to lower speed:
Use any one of the following methods to reset to a
lower speed.
•
Slow the vehicle as normal using the footbrake
pedal.
When the vehicle reaches the desired cruising
speed, push and release the <SET/—> switch
j
B downwards.
The new set speed value will be displayed in the
top of the vehicle information display.
•
Push and hold the <SET/—> switch
j
B to de-
crease the set speed in steps of 5 km/h (3 MPH).
When the vehicle information display reaches
the desired speed, release the <SET/—> switch
for the setting to take effect.
•
Quickly push and release the <SET/—> switch
j
B . This will reduce the vehicle speed by about 1
km/h (1 MPH).
The new set speed value will be displayed in the
top of the vehicle information display.
Resetting to higher speed:
Use any one of the following methods to reset to a
higher speed.
•
Depress the accelerator pedal. When the vehicle
reaches the desired speed, push and release the
<SET/—> switch
j
B .
•
Push and hold the <RES/+> switch
j
A to increase
the set speed in steps of 5 km/h (3 MPH).
When the vehicle information display reaches
the desired speed, release the <RES/+> switch
for the setting to take effect.
•
Quickly push and release the <RES/+> switch
j
A . This will increase the vehicle speed by about
1 km/h (1 MPH).
The new set speed value will be displayed in the
top of the vehicle information display.
Resuming at preset speed:
Push and release the <RES/+> switch
j
A .
The vehicle will resume the last set cruising speed
when the vehicle speed is over 40 km/h (25 MPH).
Passing another vehicle
Depress the accelerator pedal to accelerate. After
releasing the accelerator pedal, the vehicle will re-
turn to the previously set speed.
The set speed value
➄
will flash until the vehicle
returns to the previously set speed.
Cancelling cruising speed
Use any one of the following methods to cancel the
set speed.
•
Push the <CANCEL> switch
➀
.
•
Tap the footbrake pedal.
•
Push the cruise control MAIN switch
➁
. The indi-
cator
➃
will turn off.
The speed limiter allows you to set the desired ve-
hicle speed limit. While the speed limiter is activated,
you can perform normal braking and acceleration,
but the vehicle will not exceed the set speed.
When the vehicle reaches the set speed limit or if
the set speed limit is lower than the actual vehicle
speed, the accelerator pedal will not work until the
vehicle speed drops below the set speed limit.
When the actual vehicle speed exceeds the set
speed, an audible warning will be heard a short time
after the set speed is exceeded and driver interven-
tion is not detected.
When the speed limiter is on the cruise control sys-
tem cannot be operated.
WARNING
•
The speed limiter will not automatically brake
the vehicle to the set speed limit.
•
Always observe posted speed limits. Do not
set the speed above them.
•
Always confirm the setting status of the speed
limiter in the vehicle information display.
•
When the speed limiter is set, avoid hard ac-
celeration to reach the set limit to ensure that
the system can limit the speed of the vehicle
correctly.
•
When additional floor mats are used, be sure
that they are correctly secured and that they
cannot interfere with the accelerator pedal.
Mats not adapted to the vehicle may prevent
proper operation of the speed limiter.
SPEED LIMITER (where fitted)
226
Starting and driving