Dealer Modes Quick
Programming
2.1.3.1 Global
To place the unit
into the
Mode”
global settings, do the following:
1. While pressing and
the
and [ 0] buttons, switch the power ‘on“. After 2
seconds the radio enters the dealer
and
appears on the
display.
[
S
E
-
:
]
2 . While in dealer mode, press
to enter the Global Settings mode.
Table 2.3 shows the function number and function options that can be selected while in this
.
mode. While in this mode, the Channel Selector knob is used to set functions “ON” or “OFF” or
to select the setting. After a function is sat, pressing the
button stores the setting and
increments the menu to the next function option. Also, when the
button is pushed, a
beep
sound to confirm the setting.
Pressing the
button at any time while reviewing the function options will pause the unit to
exit the selection mode and revert back to the dealer mode screen. The current function option
will not be stored if it was changed. After the complete option list has been cycled through,
“End” will appear on the display. To exit dealer mode, cycle the power “off’ and then back
To review or
the function settings while in the Global Settings mode,
press
and hold
the
buttun and turn the
knob.
Monitor Momentary
MONITOR
Disables the
button.
Signaling squelch (CTCSS, CDCSS,
or
DTMF) is temporarily disabled when the
button is pressed.
Toggles between signal squelch and monitor
when the
button is momentarily pressed.
Unsquelches the receiver while the [MONI] button
SCAN OFF Dircables SCAN mode.
Page?
