1
16
Table 2.7 Dealer
Channel Settings
bandwidth is
and transmit deviation
is less than
‘ID’ will flash one time if DTMF signaling has been
selected. The DTMF code must have a minimum of 3
digits, but no more than 10 digits. If more than 8 digits
are used, the display
scroll.
A tone from 280 Hz to 3500 Hz in 1 Hz increments can
be used for
signaling. The tone sets in the TTS
table (I-16 tone sets) can be edited by using the PC
editor
and PC cable (PCRP). If no
change has been made to the
table, then only
defaults can be selected from Table 2.10.
A tone from 280 Hz to 3500 Hz in 1 Hz increments can
be used for
signaling. The tone sets in the
table (l-16 tone sets) can be edited by using the PC
editor
and PC cable (PCRP). If no
chenae has been made to the
table. then onlv
defaults can be selected from Table
‘CH
will flash once
to label entry mode. See
I\
I
Table 2.11 for all the possible characters and character
key assignment.
Any tone frequency between 67.0 Hz and 250.3 can be programmed into the
it is recommended to use the standard
CTCSS Tone
Frequencies shown in table 2.8.
Table 2.8
CTCSS Frequencies
ID Code will not show unless
is selected in step 1 of this section. DTMF and
cannot be enabled
Also, the
Two Tone Signaling code will not show unless TTS is selected in step 1 of this section.
Page 20
RELM Communications
