Cloning allows the
contents of one unit (source) to be transferred to another unit
(target). There
that can
for cloning
.
Wired
Cloning using
CCRP cloning cable.
l
Over the air cloning.
Wired Cloning
2 . Connect each end of
CCRP cable into the respective
jacks of the radii.
3 .
unit ‘on”.
Do the following with the
radii:
source Display
Target Display
4 . While pressing and holding the
and
buttons, switch the power “on”. After 2
seconds
radio enters the dealer mode
and
appears on the display.
5. Press the [LAMP] button to enter the done
mode.
will appear in the display.
6 . Press the
button to transmit the
data to the target unit. While the data is
transferred, the
LED will light on
the target unit and the busy icon on the
display will flash. When the transfer is
complete. Both displays will show “END”.
7 . To done another target unit turn off the target unit, remove the CCRP cable from the
target unit, connect the CCRP to another target unit, and switch the unit on.
8 . Press the [LAMP] button on the
unit,
appears on the display.
9 . Repeat steps 5 and 6 to done more units.
Target Display
Cloning
1
Due to the length of the transmission for the transfer, the wireless
doning process is performed with two separate data transfers
(first 0%
and second
100%)
the following with the target radio:
1. Remove the antenna.
1
2 .
prassing and holding the [LAMP] and
buttons,
switch the power “on”. After 2 seconds the radio enters
the dealer mode and
appears on the display.
Page 23
