DTMF Settings
To place the
into the ‘Dealer Mode’ for ediing the
settings, do the following:
1.
pressing and holding the
and
buttons, switch the power “on”. After 2
seconds the radio enters the dealer mode and
appears on the display.
2 . While in dealer mode, press
to
enter the DTMF
mode.
Table 2.4 shows the function number and function options that can be selected while in this
mode. while in this mode, the Channel
Selector knob and keypad (O-9,
A-D)
are used to
set DTMF functions
or
or to select the setting. After a function is set, pressing the
button stores the setting and increments the menu to the next function option. Also,
whsn the
button is pushed, a beep will sound to confirm the setting.
Pressing the
button at any time while reviewing the function options will cause the unit to
the
mode and revert back to the dealer mode screen. The current function option
will not be
it was changed. After
option list has been cycled through,
will appear on the display. To
dealer mode, cycle
power
and than back
To
or confirm the function settings while in the
Settings mode, press and hold the
button and turn the channel select knob.
(1 Oms steps)
200ms
1
RISE 100
steps)
RISE 1000
RTQT 100
(50ms steps)
RTQT 1000
The period of time that each of the
programmed DTMF
digits
are
transmitted.
The period of time between each of the
programmed DTMF
digits
The period of time that the first digit of
the programmed
is
transmitted.
The
of time between
modulated TX carrier and when the
programmed DTMF
is transmitted.
The period of time
modulated TX carrier and when the
CTCSS is transmitted.
Except for functions 31 and 32 that am set with the keypad.
When DTMF function
is enabled together with the Battery Save mode, and when CTCSS is used, the
transmit delay time should be set 300 ms.
Communications
Page
