2.
Look Back B
10. Revert CH
Il. Dwell Time
12. Dropout Delay Time
14. TOT
15. TOT Rekey Time
TOT Reset Time
31. Connect ID
32. Disconnect ID
29. PTT ID is OFF or connected and 30. Dial ID is
DTMF
37. DTMF sianalina is OFF
T O
I 7. Prioritv is fixed or selected.
I
Fiied, Selected
2. [SCN] is OFF
6. Priority is OFF or fixed.
6. Priority is OFF
6. Priority is OFF
Priority, Pr Selected
6. Priority is OFF
is OFF
I
2.
is OFF
I
I
13. Time Out Time is OFF
I
I
13. Time Out Time is OFF
I
13. Time Out Time is OFF
29.
ID is OFF or disconnected and 30. Dial ID is
OFF
37. DTMF signaling is OFF or is code SQ.
37. DTMF signaling is OFF.
37. DTMF signaling is OFF.
2.6
Function
Enhanced Global
To
the unit into the “Deafer Mode” for editing the enhanced
settings, do the
following:
1. While pressing
and
holding the (LAMP] and
buttons, switch the power
After 2
seconds the radio enters the dealer mode and
appears
on the display.
2 . While in dealer mode, press
to enter the Enhanced Global Settings mode.
Table 2.6 shows the function options that can be selected while in this mode. While in this
mode, the Channel Selector knob is used to set functions “ON” or ‘OFF” or to select the
setting. After a function is
set, pressing the
button
stores the setting and increments the
menu to the next function option. Also, when the
button is pushed, a beep will sound to
confirm the setting.
Pressing the
button at any time while reviewing the function options will cause the unit to
exit the selection mode and revert back to the dealer mode screen. The current function option
will not be
if it was changed. After the complete option list has been cycled through,
“End” will appear on the display. To exit dealer mode, cycle the power
and then back ‘on”.
RELM Communications
Page 15
