button to enter the wireless clone
will appear in the display. Adjust the channel
b
the
to the
to receive data on. Note: Pressing the [LAMP]
turning the channel
the
in 1 MHz steps.
the source radii:
and holding the [LAMP] and
buttons,
power
After 2 seconds the radio enters
mode and
appears on the display.
button to enter the wireless clone mode.
will appear in the display. Adjust the channel
b to adjust the frequency to the desired
to transmit data on. Note: Pressing the [LAMP]
turning the channel selector will change the
in 1 MHz steps.
PTT button to start cloning the first half (0%
e data.
CLONE” will appear in the displays
source and target units. Also, the “Lo” power
displayed on the source unit and the receiver
displayed on the target unit. The source’s LED
be red (inditing transmitting) and the
ED indicator will be green (indicating receiving).
ning, the two-digit counter will increment one
me on each of the displays.
3.
A
4. While pn
the
5. Press
A
select
button
8. Press
50%) of
of both
icon will I
icon will I
indicator
1
During
digit at a
When
the
charged and
7. Allow the
the
8. Pressthr
pow
transmitti
cloning,
Source Display
is successful, “END” will be shown on the displays. If “ERROR” is shown on
start the cloning process over. Make sure the batteries are fully
hat the source and target units are in close proximity to each other.
ransmitter to rest (cool down) for approximately 1 3 minutes before starting
half (50%
100%) of the data transfer.
[LAMP] button to continue cloning the second half (50%
100%) of the data.
will appear in the displays of both the source and target units. Also, the
r icon will be displayed on the
unit and the receiver icon will be
on the target unit The source’s LED indicator will be red (indicating
g) and the target’s LED indicator will be green (indicating receiving). During
two-digit counter will increment one diiit at a time on each of the displays.
“END” will be shown on the displays. If ‘ERROR” is shown on the
tart the cloning process over. Make sure the batteries are fully charged and
target units are in close proximity to each other.
When cloning is
target’s display,
Programming a
ning by Computer
from a computer is not covered in this manual. Contact RELM
for the programming cable (PCRP) and software
Page 24
Communications
