O F F
Q T
Channel to be programmed.
No receive or transmit frequency
Pressing the
button toggles no frequency to the
of the
frequency if the channel is blank
Rotating the channel selector will raise or lower the
frequency by
or
increments. If a decimal
point is shown next to the last digit of the frequency, then
the increment is
if there isn’t a decimal point
shown next to the last digit of the frequency, then the
increment is
Pressing the
key will toggle the
increment size between
and
Holding in the lamp key and rotating the channel selector
will raise or lower the frequency by
increments.
Disables CTCSS or DCS
Selecting the
key switches it from OFF to the first
CTCSS tone. Rotate the channel selector to move the
tone frequency up or down in 1 Hz increments until the
desired tone frequency is reached. If there isn’t an
asterisk shown next to the last digit of the frequency, then
the increment change is
if there is an asterisk
shown next to the last digit of the frequency, then the
increment change Is 0.1 Hz. Pressing the
key will
toggle the increment size between 1 Hz and 0.1 Hz.
Selecting the
key again switches from CTCSS to
the first DCS tone. Rotate the channel selector to move
the DCS code up or down until the desired code is
reached. The last alpha character will be an
inverting) or ‘I” (inverting). Pressing the
key toggles
the
and
Pressing the
key
toggle the DCS
selection between ‘standard’ and *non-standard’ DCS
codes. If there isn’t an asterisk shown next to the last
digit of the DCS code, then the DCS tone selection is
‘standard’; if there is an asterisk shown next to the last
digit of the DCS code, then the DCS tone selection is
‘non-standard”. Selecting the
key again switches it
from DCS to OFF.
No transmit frequency. Receive only.
Pressing the
button toggles no frequency to the start
of the transmit frequency if the channel is blank
Rotating the channel selector will raise or lower the
frequency by
or
increments. If a decimal
point is shown next to the last digit of the frequency, then
the increment is
if there isn’t a decimal point
shown next to the last digit of the frequency, then the
increment is
Pressing the
key will toggle the
increment size between
and
RELM Communications
