CHANGING YASKAWA MOTOMAN SETTINGS TO
PREPARE FOR FORGE/OS
You need to change the Yaskawa Motoman controller settings to enable communication with
Forge/OS and to enable the Safety I/O Expansion Board. These steps are only required if this
is your first time setting up Forge/OS, or if your Yaskawa controller has been factory reset.
On the Motoman pendant, turn the key to the "TEACH" position (fully counter clockwise).
1
Clear any active alarms by tapping the
RESET
button at the bottom right hand corner of
the screen.
2
Change the security mode to Safety Mode:
3
VERSION 1.0.0
© 2021 COPYRIGHT READY Robotics ALL RIGHTS RESERVED
33