THE PVCore 3D PRINTER
12/28/2016
BY RCJOSEB
PAGE 73 OF 107
PRINT BED SUPPORTS – BOM:
The Print Bed Support is assembled with the following parts:
2 x 3D printed bed support stiffeners (PB1).
1 x 3D printed front lower bed support (PB2).
2 x 3D printed rear lower bed supports (PB3).
2 x 3D printed rear upper bed supports (PB4).
1 x 3D printed front upper bed support (PB5).
3 x #8 x 1.5” screws (S8). Two are shown installed.
3 x #8 wing nuts (WN8).
3 x 0.275” x 1.5” springs (SP1).
Please note that the following parts are from the Z Axis Slide Assembly:
2 x 0.25” x 12” threaded rods (T0.25).
16 x 0.25” hex nuts (N0.25).
16 x 0.25” flat washers (W0.25).
