THE PVCore 3D PRINTER
12/28/2016
BY RCJOSEB
PAGE 40 OF 107
Z AXIS SLIDE ASSEMBLY:
The Z axis slide requires only one linear bearing (LM6UU-M or LM6UU-3D) on each side. If you are using the metal linear
bearings (LM6UU-M) you can place two of them on each side as long as they are centered vertically within the Z axis slide hole.
Please note that the Z axis slide has a top and a bottom side even though they are not marked. The bottom side is the one
where the outer edge of the threaded rod (T0.25) is closest to the outer edge of the Z axis slide (Z2).
Orient the Z axis slide (Z2) so that the bottom is resting on the table.
Insert the linear bearing (LM6UU-M or LM6UU-3D) all the way into the Z axis slide (Z2).
Tighten the #6 x 0.5” Phillips pan head screws (S0.5) until the linear bearing is held in place.
Repeat the above steps for other linear bearing (LM6UU-M or LM6UU-3D).
.