Standard 30 MF
110-700
Operator and Service Manual
Edition: 8
3-1
4361.DOC010302 AUG18.DOCX
3
Operation
3.1
Switching On and Off
Activate the speed and position sensors prior to switching on the
Standard 30 MF.
If no extern sensors are available, the current values for latitude and
speed have to be input manually after Standard 30 MF has started
completely (see chapters 3.3.1 and 3.3.2).
Cautions may be generated and displayed on the Operator Unit
when Standard 30 MF is switched on or during the Standard 30 MF
installation procedure. These cautions extinguish automatically
during/after the installation/start-up procedure.
The Standard 30 MF can be switched on or off at any time by switching the central power
supply on or off.
The Standard 30 MF starts up as soon as the supply voltage is connected. If an
Operator Unit is connected, the start screen appears on the Operator Unit after the
selftest has been completed.
3.2
Standard Operation with Operator Unit Standard 30 MF 130-627
Figure 3-1
Standard 30 MF, Screens in Standard Operation
In standard operation, the user can switch between four screens, starting from the start
page, as shown in Figure 3-1 using the
Page
key.
All four screens show the heading in large figures in the upper section.
The information in the lower section of the screen changes when switching through the
following pages with the
Page
key.
Gyro Compass
"Heading", "Roll", "Pitch"
(Start screen)
Gyro Compass
"Heading",
"Elapsed time since last latitude input",
"Elapsed time since last speed input"
Gyro Compass
"Heading", "Roll rate", "Pitch rate"
Gyro Compass
"Heading", "Rate of turn"
Page
Page
Page
Page
