Standard 30 MF
110-700
Operator and Service Manual
4361.DOC010302 AUG18.DOCX
2-24
Edition: 8
5. Press the
Set
key to confirm the selected value.
‐
The font color of the chosen baud rate setting changes to orange.
‐
All activated NMEA telegrams will be transmitted at the newly chosen baud rate.
The telegram names are followed by information on whether that
telegram is activated for transmission or not.
In the dialog, each telegram can individually be switched on or off for
transmission.
6. Use the arrow keys to navigate to the current
on
or
off
value after a telegram name.
Important note:
If too many telegrams with low baud rates should be enabled, the
Standard 30 MF automatically increases the baud rates during
activation process without a feedback. To check whether this has
happened, it is recommended to open the
dialog SERIAL OUTPUT
DATA SETUP – NMEA again.
If a lower baud rate should be enforced for a telegram, the number of
activated telegrams must be reduced or the output rates for other
telegrams must be reduced.
7. Pressing the
Set
key once reverses the current value.
‐
The transmission of the telegram is activated (
on
) or deactivated (
off
).
‐
An activated telegram is refreshed at the refresh rate that is currently set in the
OUTPUT RATE
column.
In the
OUTPUT RATE
column, the refresh rate can be set for each
telegram individually.
