vi
S1 Wheel and Tiller Pilots Commissioning Guide
the product, but may cause the loss of some information and may change the
operating mode.
• Raymarine specified cables are used. Cutting and rejoining these cables can
compromise EMC performance and must be avoided unless doing so is
detailed in the installation manual.
Suppression Ferrites
If a supplied cable is fitted with a suppression ferrite, the ferrite must not be
removed, unless it is necessary to facilitate installation. Any ferrite thus removed
must be replaced in the original position immediately installation is complete.
If additional suppression ferrites are required, use only ferrites supplied by
Raymarine.
Connections to Other Equipment
If Raymarine equipment is to be connected to other equipment using a cable not
supplied by Raymarine, a Raymarine suppression ferrite MUST always be
attached to the cable near the Raymarine unit.
Waste from Electrical and Electronic Equipment
(WEEE) Directive
The Waste from Electrical and Electronic Equipment (WEEE) Directive requires the
recycling of waste electrical and electronic equipment. Whilst the WEEE Directive
does not apply to some of Raymarine’s products, we support its policy and ask you
to be aware of how to dispose of this product.
The crossed out wheelie bin symbol, illustrated above, and found on our products
signifies that this product should not be disposed of in general waste or landfill.
Please contact your local dealer, national distributor or Raymarine Technical
Services for information on product disposal.
Handbook information
To the best of our knowledge, the information in this handbook was correct when
it went to press. However, Raymarine cannot accept liability for any inaccuracies
or omissions it may contain. In addition, our policy of continuous product
improvement may change specifications without notice. As a result, Raymarine
cannot accept liability for any differences between the product and the
handbook.
81282_1.book Page vi Monday, October 2, 2006 1:58 PM
