10
S1 Wheel and Tiller Pilots Commissioning Guide
Securing the Cables
1. Strip at least 5 mm (¼ “) of insulation from the end of each cable
2. Use a small screwdriver to push the small plastic lever on top of the terminal
and release the cable clamp
3. Insert the stripped cable and release the lever to grip the cable
1.7 How to connect SeaTalk equipment
You can use SeaTalk to connect your SmartPilot to:
• additional SeaTalk controllers: you can use any controller to operate the
SmartPilot and view autopilot information
• SeaTalk equipment (such as instruments, chartplotters, radar and GPS):
• the SmartPilot can use information from this equipment to enhance
course keeping and provide additional features.
• you can also display information from the SeaTalk equipment on the
SmartPilot controller.
The following illustrations show some typical ways to connect simple SeaTalk
systems.
Single control unit, single power supply
The simplest type of system has the SmartPilot computer providing power to a
single SeaTalk bus that includes a single controller and several instruments.
Note:
Depending on the number of SeaTalk units and the total length of SeaTalk cabling,
you may need to provide12 V power supply to each end of the SeaTalk bus (‘ringmain’
style). Refer to the instrument handbook for more information.
D6300-1
Single control unit, single power supply
SmartPilot
controller
SeaTalk instruments
SeaTalk bus
Course computer
power supply
(via breaker/fuse)
SmartPilot
computer
SeaTalk
81282_1.book Page 10 Monday, October 2, 2006 1:58 PM
